Factory used electric scissor lift, mobile platform

1. The lifting platform has been inspected and debugged at the factory before delivery. All the technical indexes have reached the design requirements. When using, the lifting platform only needs to be connected with the power supply, and the hydraulic system and electrical system need not to be adjusted.

2. The platform should be carefully checked before use of hydraulic, electrical systems, no leakage or naked leakage before use.

3. Lifting platform in use, the four legs should be firmly supported on a solid ground (with the wheel to leave the ground shall prevail) if necessary, the use of sleepers.

4. Lifting platform empty run 1-3 times before loading operation.

5 load center of gravity should be as far as possible in the center of the table.

6.Guard railings at both ends of the movable door should be locked after the lock operation.

1, Maintenance introduction
a. Wheels, countershafts and bearings, cylinder pin and bearing, jib hinge shaft and bearing wear.
b. All parts are filled with some lubricants to extend the service life of bearings.
c. Hydraulic oil and oil level. Lifting platform throughout the rise, in this position, the hydraulic floor should be higher than the bottom 40 to 50 mm. If it is found that the hydraulic oil is dark, sticky or gravel and other foreign objects should be promptly replaced (winter replacement 32 # hydraulic oil, summer 46 # hydraulic oil. In particularly cold northeast, should be replaced transformer hydraulic oil).

2, Mid-year inspection
a, According to the order of six months or 500 hours prioritized.
b, The whole platform will rise and fall, into a brace.

1.Loading capacity----200KG, 250KG OR 300KG......?

2. The size of the table-----?

3. Working height------3m, 6m, 10m, 12m......?

4. Driving mode ----Diesel engine or Hydraulic or Electric or Battery ?

5.Fixed type (without wheel) or Trolley (with wheel) ?

-Wide chassis makes the lower part of the Equipment which can bear the load balance to enhance stability.
-355/55D625 Solid Tyre, Factory used electric scissor lift, mobile platform can keep stable not only in a variety of complex conditions but also enhance the ground friction then mobile platform lift is more stable in operation and climbing easier.
-mobile platform lift The steering system adopts double oil cylinder and Hydra steering system with 40Cr steering linkage to ensure the same direction.
-Floating leveling device will start automatically when the device encountered under the condition of uneven groundto ensure the balance of equipment Factory used electric scissor lift, mobile platform with slope of 6 degrees then strengthen the safety and adaptability.
DFGXSDFGBA
-360°continuous rotationwith 50Cr rotary support
-Emergency safety pump. mobile platform lift The operator can use emergency safety pump to fall safelywhen the equipment is working at high altitude which can not be down.
-Constant pressure pump of Danfoss USA or Rexroth Germanit avoid oil leakage caused by gear pump damage in long -term construction
-Factory used electric scissor lift, mobile platform of centralized electric control box is used to ensure the safety of equipment operation
-Ground control console and platform control console the former has a large screen display with self diagnostic screen without connected mobile platform lift to the computerthen customers can easily understand the calibration status of equipment and parameters which is convenient debugging and testing.
-Controller of IFM Germany can enhance system stability
-Turntable safety lockto avoid the damage in the transport mobile platform lift and maintenance of arm rotation
-Swing-out engine bracket - provide the world industry closest to the engine design easy maintenance and repairs.
-Glass fiber Factory used electric scissor lift, mobile platform steel cover make the whole equipment nice and durable